• Power LED normally on when powered on • Zigbee/BLE/Z-WAVE LED is flash when the signal come • Network LED is flash, When the gateway can access the Internet • Ethernet LED is flash, When the network port is plugged into the Internet cable • LTE Signal LED, It indicates the signal strength of LTE
Reset Button
The reset button is hole button, After pressing the reset button for more than 5 seconds, the Gateway will be restored to the factory settings.
I/O Port
4 digital input channels DI State "1": +10~+30V State "0": 0~+3V 2 digital output channels DO Maximum load 5A@30VDC or 250VAC 2 analog input channels AI Current signal: 0-20mA, 4-20mA Voltage signal: 0-5VDC, 0-10VDC Choose one of the above 4 ranges
• TX power up to13dBm (20mW) • RX sensitivity: @100kbps-97.5dBm • Range: 100 meters minimum, open filed • Default Frequency: 916MHz( Different country with different frequency) Pls check the z-wave frequency band table
RF Factory Test Mode
• Setting the Board into the test mode, using the Iqexl-ws that can test the Wi-Fi, Zigbee. • Please refer to the DUSUN Test Specification for details.
4.质量保证要求
4.1质量信息
Quality &Testing Information
Information Description
Standard(Yes) custom(No)
ESD Testing
Yes
RF Antenna Analysis
Yes
Environmental Testing
Yes
Reliability Testing
Yes
Certification
FCC,CE, Bluetooth certification, zigbee certification, PTCRB